Mini Enduro Rules

FINALIZED

Car Rules

Any 1/32 IMSA Group C Car
(Slot.it, Mr. Slotcar, Revell/Monogram, etc. The slot.it group c cars can be identified on their site.)

Wheels must remain Stock
Axles must remain stock
PPR tires designed for the stock wheel must be used.
Front tires must remain stock
True tires and wheels
May coat the front tires
Oil and grease as needed
Remove front and rear axle slop (no chassis mods)
Add lead
Change lead wires
Braids Must be copper
Glue in motor
Glue in bushings
Create chassis rock
You may glue or tape in motor pod to fix or limit travel
May use motor of choice
Any motor configuration
May use gears of choice

Race Rules

Qualification begins at noon

Drivers will be assigned teams according to qualification

No Track Calls except for track conditions

Heat and race distance to be determined by racer response. Goal is for a 3 hour enduro.
After Hours race to be determined

Hey Gary, can I run any rear tire I can make fit the stock rim? How aboiut gearing? I think the stock gearing with a stock Slot-it motor might be a little too severe for a short track.

Updates Posted.

The track will be in the NASCAR configuration.

You'll forgive my ignorance Gary, is that the circuit we've been running.

Any motor, any gears allowed

Yes to both youse two.

I knew that. I can read. I was ansewering Ken. But thanks for the back up.

Race 2 of the Sebring Chassis Series will be held before the enduro. Check the calendar for the schedule.

Looking forward to it.

I'll have to pass on this one.

Cancel the series race on the enduro race day, we'll race the sebring cars on February 2nd.